I picked this up some 7 or so years ago..and its been sitting in a corner ever since. Broken table has been repaired properly. It needs to be reassembled and tested. Might need a bit of turcite under the slide..maybe not.
Its available in Chino, California, for the next couple weeks. After that..I haul it up north and put it into my shop. I really have zero need for it..its small, but would make a wonderful little hobbyist mill or gunsmith mill
Gunner
3-phase? What HP? I've been wanting a mini-mill forever. That looks heavier-duty than a HF mill. ;)
On 4/2/2018 4:41 PM, Larry Jaques wrote: ...
The looking is predestined and they cannot not look.
Is it because it doesn't have much depth to it, or the Seiki half of it? Or were they beasts to keep running?
You did? Why didn't you tell me? More info, please. Google doesn't have a single hit.
That was the trip I had the flu, right? No wonder I don't remember it.
OK, thanks. What does that thing weigh? Size, etc., please?
stil available?
Soon!
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.