1. Home
  2. ⏣ General Metalworking
  3. Seeking manual for Series 6/Base M3 Trav-a-dial

Seeking manual for Series 6/Base M3 Trav-a-dial

I've got a Series 6 Trav-a-dial with M3 base but a manual for a different
series & base. The installation looks pretty simple but the base features
have enough difference that I'd like to avoid messing it up. Does anyone
have a manual that that could be emailed?
TIA
Reply to
Mike Henry
Loading thread data ...

Further Reading

  • trav-a-dial accuracy

  • Facts:I picked up a used trav-a-dial for my lathe. It came will all instructions...

  • a note on trav-a-dial repairs

  • thanks to the good offices of one of the NG denizens, I acquired a couple of...

  • Removing dial bezel on silver Trav A Dial?

  • After some 30+ years of service, a chip finally found it's way insidethe old...

  • How a Trav-A-Dial encoder works

  • I bought a Trav-A-Dial from a fellow poster here. It's one of the oneswith a...

  • Bridgeport Slotting head E series manual

  • Anyone have a manual for this thing? We finally dusted it off and set it on our...

  • Turn your Trav-A-Dial into DRO kit proposal

  • I've been learning about encoders. All the DROs use some kind ofencoder....

  • Seeking 4" dial capiper

  • Yeah, if all I wanted was a 4" dial caliper, I'd just have to walk in to my...

  • How do I re-zero my 6" Starret dial calipers?

  • I have a pair of Starret 6" dial calipers and I must of got a chip inthe gear...

  • Owner's manual for Gorton tool grinder Model # 285-6

  • Hello,I just purchased a Gorton tool cutter-grinder Model #285-6 off ofE-Bay. I...

  • Manual for a Wicksteed saw?

  • Does anyone have a manual for a Wicksteed Hydramatic power hacksaw I could copy,...

  • Bridgeport series II manual

  • I have just bought Bridgeport series II vertical milling machine. Can someone...

  • Dial Test Indicator Pointers

  • A probably really stupid question about dial test indicators. I stumbled across...

  • Replaement dial cover for B & S 6" Dial Daliper

  • I have a B & S dial caliper with a broken crystal - #599-579-5, Isthere a place...

  • OT: Shippin a Shaper?

  • I have found a small 7" shaper I am intertested in buying. The problem is that...
  • « previous thread

  • Aluminum question

  • Looking for type of aluminum that is used in electronic chasis. Bendable,...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.