I was looking at a small Fray 'All Angle' model 2. It uses tool holders that I did not recognize. The taper section is 2" long, 3/4" at the small end, 1-1/4" at the fat end. Does this ring a bell?
I was looking at a small Fray 'All Angle' model 2. It uses tool holders that I did not recognize. The taper section is 2" long, 3/4" at the small end, 1-1/4" at the fat end. Does this ring a bell?
Have something to add? Share your thoughts — no account required.
Ask the community — no account required