Im looking for a hobby guy do make some parts for me. This is about as easy as it gets. 5/16 shaft 3 inches long with .680 inches of one end turned down to 1/4 inch, and a snap ring groove in the end. This will be 303 stainless steel. I will have the matirials shipped to your door so you have no upfront cost. I am willing to pay .45 cents each and have about
500 made to start. I will pay set up time with in reason. Again this is a job for a small shop who may not be that busy. Tolerance can be .01 either way on the 1/4 diameter. The length can vary by as much as 1/8 inch. Then length of the turned portion can vary .05
"Democracy is two wolves and a lamb voting on what is for lunch. Liberty is a well armed lamb protesting the vote."