Shot in the dark. Trying to help a friend, he has a coil that went bad. Its a 115VAC model 11-143 Solenoid Coil. Have a call into Decco, but he told me it was a special coil no longer made.....
Its for a 115VAC Hydraulic Power pack that drives the ram on his Cold Saw. The Valve manifold itself is a bit odd. Is there a web site that shows the different standards for such a manifold on a power pack?
Marty
different standards for such a manifold on a power pack?
Don't know much about your solenoid, but, I've rewound several on the lathe. Got a cheap revolution counter ($ 5) from Enco, let the mag wire through a rag held in my hand and slowly rewind the coil. You can check the wire gauge with a micrometer. You can count turns by either unwinding the coil (slow) or cutting through it with a sharp knife or hacksaw and then counting the ends.
Ivan Vegvary
Send me the dimensions, and/or pix, I may have a box full of them.
"Tom Gardner" wrote in news:cTbJc.985$ snipped-for-privacy@newssvr31.news.prodigy.com:
Thanks Tom! Email with pics and dimensions sent. Fingers crossed!! Marty
Have something to add? Share your thoughts — no account required.
Ask the community — no account required