⏣ General Metalworking

30777 Threads Posts
to

GortonBook available

I just spent one of the most boring hours in a long time scanning the Gorton Pantograph book, circa 1950 This should co...
5 comments posted 20yrs
posted by gunner
5 comments posted 20yrs posted by gunner

Carry On!

Going to the cabin for a few days to watch the icicles form. Do your best without me. If anything happens, Ned is in cha...
2 comments posted 20yrs
posted by deserttraveler
2 comments posted 20yrs posted by deserttraveler

shop made reamer described by Gingery

I found some NOS idler gears for my Rockwell 11's quick change on ebay. One fits pretty sweet, the bore on the other's...
9 comments posted 20yrs
posted by rohamm
9 comments posted 20yrs posted by rohamm

pc software for bolthole layout?

Hi, I have a pc with winXP. My measurements never seem quite accurate and take a long time even with graph paper. Is th...
4 comments posted 20yrs
posted by sdfs
4 comments posted 20yrs posted by sdfs

shop electrical question

If all things are equal as far as usage, is it valid to assume that since amperage ratings for three phase motors are a...
12 comments posted 20yrs
posted by weyland
12 comments posted 20yrs posted by weyland

tool for pinching the end of a steel rod?

Is there a tool that puts tremendous force on metal, like to pinch the end of a steel rod so that it flattens out a lit...
14 comments posted 20yrs
posted by jdoe
14 comments posted 20yrs posted by jdoe

Use of Miter Saw?

I am new to home improvement. Saw a big sale of miter saw at Home Depot. What are good uses of a miter saw versus other...
5 comments posted 20yrs
posted by zcarenow
5 comments posted 20yrs posted by zcarenow

Rockwell Mill 21-100

Anyone parting one out??? Or have some parts???? Need fine downfeed and right side handle assy for the table...
0 comments posted 20yrs
posted by clif
0 comments posted 20yrs posted by clif

--->BRIDGEPORT Mill Model Q's!!! HEEEELLLLLPPPP!!

Help! Ok, I put money down on a Bridgeport Mill, SN: 131234 (on the front end of the area between the ways above the cr...
8 comments posted 20yrs
posted by bearlabs
8 comments posted 20yrs posted by bearlabs

computer question

Well, I can't figure it out, so I will ask youse guys ......... When I bring up my home page, or ebay, or lots of sites...
8 comments posted 20yrs
posted by deserttraveler
8 comments posted 20yrs posted by deserttraveler

Lapping a brass-cylinder - a trick

Hi, I just wanted to share the experience I had today. Maybe this trick is not new, but it is new to me. And I found it...
0 comments posted 20yrs
posted by muellernick
0 comments posted 20yrs posted by muellernick

I love a good pen

In the space race with Russia, there came a time when the US realized that normal pens would not work in weightlessness...
15 comments posted 20yrs
posted by deserttraveler
15 comments posted 20yrs posted by deserttraveler