⏣ General Metalworking

30777 Threads Posts
to

Cincinnati 220-8 Questions

Hello, I have a cincinnati 220-8 machine. Some problems I'm facing are:- -grinding is uneven.(ovalty). -accompanied wit...
0 comments posted 21yrs
posted by sachinuc
0 comments posted 21yrs posted by sachinuc

Chainsaw recommendations

We went to the cabin this past weekend. I am going to need a chainsaw for cutting firewood, and clearing some dead wood...
82 comments posted 21yrs
posted by deserttraveler
82 comments posted 21yrs posted by deserttraveler

Wire rope question

I made up a wire rope cable to put across a driveway. One end was already looped with a thimble and ferrule. On the oth...
25 comments posted 21yrs
posted by deserttraveler
25 comments posted 21yrs posted by deserttraveler

Buffer size/speed for brass

Does anyone know the recommended SFPM for buffing brass, or have a recommended combination of horsepower, wheel size an...
2 comments posted 21yrs
posted by diaphone
2 comments posted 21yrs posted by diaphone

spray paint can question

Is there any safe way to open a still-pressurized can of spray paint with a completely plugged nozzle, to get the paint...
75 comments posted 21yrs
posted by grant
75 comments posted 21yrs posted by grant

Comprehensive Drill Press Manufacturer List

I'm looking for a compressive list of drill press manufacturing companies... It could (and it would be good) include mil...
1 comments posted 21yrs
posted by bob
1 comments posted 21yrs posted by bob

Connecting encoders

I need to connect encoders to moving slides. I wanted to do this with a 5 to 1 increase in encoder revolutions so that...
15 comments posted 21yrs
posted by etpm
15 comments posted 21yrs posted by etpm

Standard tool tapers

I looked at a small Fray mill last night that uses tool holders. Does any one have a nice link to standard tool holder...
1 comments posted 21yrs
posted by spamless
1 comments posted 21yrs posted by spamless

Storm recovery

We had a storm. Not Katrina or Rita scale, but it did tear things up some in Minneapolis. 95 hours down, but we're up a...
43 comments posted 21yrs
posted by dforeman
43 comments posted 21yrs posted by dforeman

way OT help requested

i've been lurking here for years and have interjected something now and again but am usually put to shame by the wealth...
5 comments posted 21yrs
posted by 5joneses
5 comments posted 21yrs posted by 5joneses

[OT] IR remote repair

Is there any way to repair those membrane keyboard switches with the carbon-like button that makes contact on a PCB? So...
17 comments posted 21yrs
posted by tom(nospam)
17 comments posted 21yrs posted by tom(nospam)

Lathe/BP repairman in NY/NJ/LI area?

Awl-- Housecalls in Queens? For SouthBends, Clausing Colchesters, BPs/clones, etc. Email me, my buddy there needs a mac...
0 comments posted 21yrs
posted by physical
0 comments posted 21yrs posted by physical

make a lathe test bar

I'm needing a one inch lathe test bar. Finding ground and polished one inch material is a piece of cake. The bar needs...
16 comments posted 21yrs
posted by karltownsend.NOT
16 comments posted 21yrs posted by karltownsend.NOT