⏣ General Metalworking

30777 Threads Posts
to

1/2" straight shank to 3/8 x 24 threaded arbor

Does anyone know where I can find this arbor. I have looked at Mcmaster, Enco, MSC and can't find anything. I have a 3/...
20 comments posted 21yrs
posted by terry.gaston
20 comments posted 21yrs posted by terry.gaston

repairing a broken aluminum casting

I adapted a technique used by guys that repair boat propellors with TIG to repair a broken casting. http://users.goldeng...
7 comments posted 21yrs
posted by dforemanNOSPAM
7 comments posted 21yrs posted by dforemanNOSPAM

Torque for Bolts on a Bison 8" 3 Jaw

I am getting ready to mount my Bison 8" 3 jaw on its backing plate and cannot find a spec on torque for the bolts that...
3 comments posted 21yrs
posted by Sierevello
3 comments posted 21yrs posted by Sierevello

Drop box use

How does one use the "drop box". I need to identify some chisels. Or at least I think they are chisels. For a wood lathe...
10 comments posted 21yrs
posted by rwatson767
10 comments posted 21yrs posted by rwatson767

shop press feet -- casters?

I have a little 20 ton H-frame shop press. It would press just fine hanging from a loop, i.e. it doesn't rely on the gr...
9 comments posted 21yrs
posted by grant
9 comments posted 21yrs posted by grant

Gallic 14 lathe

Hi all..Anyone had any experience with or have any knowledge of a Gallic 14 lathe?I was just offered one for $1800.that...
0 comments posted 21yrs
posted by steve
0 comments posted 21yrs posted by steve

working with rough aluminum castings?

One of the guys in our local club took pity on my broken surface grinder table end casting (the part that stands up to...
12 comments posted 21yrs
posted by grant
12 comments posted 21yrs posted by grant

Lathe collet chuck questions

I am prospecting around for a used collet chuck for my lathe which has a L-0 spindle. It appears that there are at leas...
19 comments posted 21yrs
posted by lplas
19 comments posted 21yrs posted by lplas

Possible to make a welding rod storage container

Is it possible to cheaply do? COuld I make a metal container and just put a small appliance lightbulb in there? WOuld it...
4 comments posted 21yrs
posted by stryped
4 comments posted 21yrs posted by stryped

Horn for my tractor

Hello all, This is a simple question and I know someone will have the answer even if it a bit off topic. I have a 755 J...
21 comments posted 21yrs
posted by doggiepoint
21 comments posted 21yrs posted by doggiepoint

motor source

I need a gear reduction motor. Where should I look for one that won't cost me an arm and a leg? Steve
17 comments posted 21yrs
posted by desertNOSPAMtraveler
17 comments posted 21yrs posted by desertNOSPAMtraveler

Cone roll

Every so often someone posts here wanting to know how to make a sheetmetal cone. Here's what ya need: http://cgi.ebay.co...
0 comments posted 21yrs
posted by rex
0 comments posted 21yrs posted by rex

OT? Rapid Prototyping

Does anyone know of a group on Rapid Prototyping? - OR - I am thinking of buying a Solid-Scape rapid prototyping machin...
0 comments posted 21yrs
posted by eric.d.wilson
0 comments posted 21yrs posted by eric.d.wilson