⏣ General Metalworking

30778 Threads Posts
to

Building voltage regulator for 3ph generator

I have an old 15 KW 3ph generator that is missing the voltage regulator. The alternator has a 12 volt generator on the...
33 comments posted 21yrs
posted by SBAER
33 comments posted 21yrs posted by SBAER

FS:JET BD-920N lathe

Std. features: 3/4hp, 125V, 9" swing, 20" b/c, inch dials, 1-1/2"x8 spindle, 3-jaw, faceplate, dead centers, 4-way t/p,...
0 comments posted 21yrs
posted by wilste
0 comments posted 21yrs posted by wilste

taper attachment question

Hello, I have an old Cincinnati 13x60 lathe the I would like to use for long tapers. There is a "taper attachment" or t...
4 comments posted 21yrs
posted by thebruce
4 comments posted 21yrs posted by thebruce

Whait is it? XLVII

http://puzzlephotos.blogspot.com/ Rob
58 comments posted 21yrs
posted by rhvp67
58 comments posted 21yrs posted by rhvp67

affordable CNC with decent tolerances and speed

I would like to CNC vertical mill some 2024-T3 aluminum parts from stock approximately 12"X12"X2". The parts are about...
24 comments posted 21yrs
posted by joe_d_builder
24 comments posted 21yrs posted by joe_d_builder

Dural

Does anyone know the alloy number for the modern equivalent of dural? Thanks. Jim
5 comments posted 21yrs
posted by jriser
5 comments posted 21yrs posted by jriser

Shear pin material

Hi all, I've just sheared the shear pin for the X power feed on my Gorton 8D. Obviously, I'd like to replace it. I have...
25 comments posted 21yrs
posted by pgrey
25 comments posted 21yrs posted by pgrey

OT: D-Link wireless router scam

I try not to post off-topic but I needed to get this off my chest, and I know there are people here who will appreciate...
14 comments posted 21yrs
posted by mtlwright
14 comments posted 21yrs posted by mtlwright

Broom Handle Thread Specs?

Does anybody know the dimensions for a broom handle thread? I had no luck with Google. I need to make a clamp with exte...
19 comments posted 21yrs
posted by keillorp135
19 comments posted 21yrs posted by keillorp135

1018 Steel Elongation

I am currently getting into metallurgy and going through the book I have I came upon a question that I was unsure on th...
5 comments posted 21yrs
posted by tazznchop
5 comments posted 21yrs posted by tazznchop

Taig Lathe Cross Slide Problem

Bought a Taig lathe about six months ago. I am a little dissapointed in the quality, particularly the cross slide. It b...
5 comments posted 21yrs
posted by msterspy
5 comments posted 21yrs posted by msterspy

Why did this rifle blow up?

I caught the last half of a shooting show where the theme was black powder vs modern high power smokeless powder. To de...
8 comments posted 21yrs
posted by etpm
8 comments posted 21yrs posted by etpm

Spiral staircase construction

After spending too much time trying to find plans for a spiral staircase, or a kit for a reasonable cost, I've decided...
10 comments posted 21yrs
posted by nospamplease
10 comments posted 21yrs posted by nospamplease