⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30749 Threads Posts
to

Free - Foundations of Mechanical Accuracy

If you know what this book is, you may know that it sells for $200 on Amazon ($150 from Moore Tool Co.). But the Intern...
49 comments posted 8yrs
posted by huntres23
49 comments posted 8yrs posted by huntres23

Can't Win Some Days

I'm learning a lot... like you hardly need any torque on the thrust bearing retaining nut on this KMB1. I learned how t...
16 comments posted 8yrs
posted by none
16 comments posted 8yrs posted by none

Making a 16-cyl Stirling engine

This is an especially nice video of machining and running a 16-cylinder Stirling engine. There's lots of very small-sca...
1 comments posted 8yrs
posted by huntres23
1 comments posted 8yrs posted by huntres23

Pencil making photos

It's only pencils, but these photographs of one of America's last pencil-making factories and machinery are supurb: http...
34 comments posted 8yrs
posted by huntres23
34 comments posted 8yrs posted by huntres23

Tight Job Market Aids Applicants Once Shunned

What will Wieber's excuse for his continued lack of employment be now? A rapidly tightening labor market is forcing com...
0 comments posted 8yrs
posted by another.jaques.fuckwit
0 comments posted 8yrs posted by another.jaques.fuckwit

Raise a glass to Teenut.

It's a little belated, but it's time again to raise a glass. Hard to believe that it has been 17 years. Mourning his pa...
5 comments posted 8yrs
posted by pkdickman
5 comments posted 8yrs posted by pkdickman

Re: Go back to your shithole newsgroup

>>> >> -- >> >> Ed Huntress from N.J. >> > >> >I hope you saved some money for a bottle of Summer's Eve, you >> >douche...
14 comments posted 8yrs
posted by huntres23
14 comments posted 8yrs posted by huntres23

Chuck Speeds

I recently got a good deal on a new old stock Bison 10" independent 4 jaw. Its the model with the FPJ logo instead of t...
5 comments posted 8yrs
posted by none
5 comments posted 8yrs posted by none

Anybody know Bridgeport power feeds?

The power feed on my Bridgeport mill has started making a bad noise when moving in one direction. The mill and power fe...
4 comments posted 8yrs
posted by etpm
4 comments posted 8yrs posted by etpm

Turning a taper between offset centers

After much adieu over nothing I suppose (since at the moment I only have one to do) I decided to turn a tapered mandrel...
12 comments posted 8yrs
posted by none
12 comments posted 8yrs posted by none

ACBs for the KMB1

Anybody just happen to have a set of new old stock Fafnir MM9306WI2 DUH ACBs they'ld sell relatively cheap? I see one o...
4 comments posted 8yrs
posted by none
4 comments posted 8yrs posted by none