will "black bar" weld OK ? I want to make a heavy roller with a 35 mm spindle . Black bar is so much cheaper the bright bar , but will it weld ? regards Phil
black bar
Oct 22, 2006
2 Replies
Should be no problem at all to weld, it's black because it's hot rolled and has a layer of oxide. Even if you don't grind this off it won't stop your welding.
Tim
Dutton Dry-Dock Traditional & Modern canal craft repairs Vintage diesel engine service
On or around 22 Oct 2006 07:53:11 -0700, snipped-for-privacy@fastmail.fm enlightened us thusly:
's all made of steel. black bar is fine, provided you don't want accurate size to fit a bearing, of course.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required