1. Home
  2. ⚙ Model Engineering in the UK
  3. Bridgeport interact belt change

Bridgeport interact belt change

Anyone ever done this? If so, any particular pitfalls to look out for?
Bob
Reply to
Emimec
Loading thread data ...

Further Reading

  • Bridgeport interact belt

  • The spindle drive belt on my Bridgeport series 1 Interact has started to slip. I...

  • Bridgeport Series II Interact 2 back gear ratio

  • I need to know the exact back gear ratio for Bridgeport Series IIInteract 2. I...

  • Bridgeport Interact wanted

  • I'm looking for a good condition Bridgeport Interact (1 or 2) with aTNC151B...

  • control parameters (in notepad file) for Bridgeport series II interact 4

  • I have Bridgeport series II interact 4. I lost my parameters. does anyone have...

  • Bridgeport Interact Gurus ????

  • I've come to the conclusion I need (well ok WANT !) a bigger CNCmill - my...

  • Bridgeport Interact parameters wanted

  • Has anyone got a full set of parameters for a Bridgeport Interact series 1 with...

  • Is this a scam? Bridgeport Interact

  • This rather nice Bridgeport Interact has appeared on eBay. Seller has zero ...

  • how to change original bridgeport feed to new servo unit

  • I have an old Bridgeport machine 1968 1hp with the old style feed for the...

  • Bridgeport Interact speed control valve

  • Has anyone ever had dealings with the re sealing of the valve that controls the...

  • Any Bridgeport Interact experts around?

  • My series 1 Interact has a nasty habit of knocking out the controller, a...

  • Quicky Belt Change

  • Is it just me or did anyone else wonder about properly adjusting the belt...

  • Bridgeport Interact 1 Heidehain Controls

  • I know starting a new project should wait until I finish the current projects,...

  • Bridgeport V belt Required

  • Belt starting to disintegrate.Anyone know part number for replacement belt from...

  • Bridgeport Interact 2 tapping capacity

  • With the 2-3 HP motor, variable pitch drive and back gear, I'd expectyou...

  • Sanding Belt Direction?

  • Is this important? I have a vertical machine in which I tend to wear out th e...

  • welding supplies

  • thought this lot a mention. Ordered bronze rods yesterday, arrived lunchtime...
  • « previous thread

  • Transwave 4KW rotary 3 phase converter

  • I have a 4 kW (5.25 HP) Transwave rotary three phase converter that is now...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.