FS: Entire workshop, inc Bridgeport Mill, Myford ML7 etc

Hi all,
I am disposing of my entire amateur engineering workshop, to include:
Bridgeport Series-1 Mill
------------------------
3-phase motor, with single to 3-phase converter & electronic speed
control. Power cross feed, Mill Vice, various collets, clamping kit,
slitting saws, Drill chuck, Clarkson end mill holder, various end
mills, Dial Gauge, Boring head, Mitutoyo Digimatic Caliper gauge,
Heidenhain DRO. Recently overhauled by local specialist, and in *very*
good condition.
Myford ML7
----------
Single phase motor, Burnerd 3 jaw chuck, 4 jaw Chuck, large 4 jaw
chuck,
backplate, various steadys, Live center, 2 x Drill chucks,
screwcutting
gears, much tooling
Large metal cut-off saw, various other bits.
Photos of the machines can be seen at :
formatting link

I would like to sell the whole workshop, in one go, expecting IRO
£1900, & open to negotiation!
Thanks,
Peter DOT Moreton AT virgin DOT net
Reply to
Peter Moreton
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.