Spring Steel

- K
- Kevin
  
  Contact options for registered users
posted
16 years ago

Thu, Dec 27, 2007 9:51 AM

I need a few lengths of spring steel for a project. About 15-20mm wide and 0.5 -0.8mmm thick by 600mm long. They need to be H&T ready to use. Any suggestions for a source? Most of the suppliers only want to sell me a roll of the stuff, and I only want two or three pieces.

Regards Kevin

Loading thread data ...

- M
- Mike H
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Thu, Dec 27, 2007 10:24 AM

In message , Kevin writes

Try Mallard metals (usual disclaimer)

- T
- Tony Jeffree
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Thu, Dec 27, 2007 10:33 AM

Make friends with a local clock repairer? They are bound to have old/new clock springs lying around.

Regards, Tony

- A
- Alan Marshall
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Thu, Dec 27, 2007 4:52 PM

Try Folkestone engineering supplies :

formatting link

Their spring steel is not hardened and tempered but they do offer that service. They will sell any length you want.

Alan

- D
- Dave A
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Thu, Dec 27, 2007 5:50 PM

I don't know if Mallard do what the OP needs, but in general I can highly recommend them.

Dave

- P
- PG1D/PA-11Ã12
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Sun, Jan 6, 2008 8:12 PM

"Kevin" schreef in bericht news: snipped-for-privacy@4ax.com...

Are they not applied in womens corsettes?

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.