I was wondering if there was an easy way to put a datum axis on an ellipse. Any thoughts? I have tried the datum axis creation tool, but it does not allow multiple references if I pick one surface of the ellipse.
Thanks, Carey
I was wondering if there was an easy way to put a datum axis on an ellipse. Any thoughts? I have tried the datum axis creation tool, but it does not allow multiple references if I pick one surface of the ellipse.
Thanks, Carey
When you are in sketcher creating your ellipse, pick Sketch/Axis Point, and place it at the centre of the ellipse. This will show up as an axis in your model.
Worked perfectly.
Thanks, Carey
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.