newbie question: radial pattern creation. Can´t make it work.

Hi NG.
I´m an engineering student (mechanical) and I can´t make a radial pattern
using proe 2001.
I´ve made a cylinder (protrusion) with a cut and I want to pattern it,
radial.
I don´t know what´s wrong, but hope to get some feedback. Any feedback will
be greatly appreciated.
Proe says: "WARNING: Unattached CUT was detected". What does this mean?
I´ve only pointed out a pattern dimension for first direction (the angle).
Any inputs?
Regards,
Martin Jorgensen
Reply to
Martin Jorgensen
Loading thread data ...

Site Timeline

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.