Handheld ESP32 internet radio with custom PCB and gamepad controls

Nov 16, 2026 Last reply: 22 hours ago 4 Replies
Jump to replies (4)

Most hobby internet radio projects I come across end up as a breadboard tangle or a perfboard rat's nest with a speaker zip-tied on. This one goes a different route: a proper custom handheld unit, already at version 7, built around an ESP32 and running the open-source yoRadio firmware. KOKENSHA TECH clearly treats this as an evolving product rather than a one-off experiment, and that shows in the polish of the design.



The construction path is a serious one. Schematics and board routing were done in KiCad, then fabrication and surface-mount assembly were handled commercially through PCBWay. Pin mapping was worked out with the yoRadio web-based configuration generator, which seems like a sensible way to keep the firmware side in step with the board layout. The signal chain runs from an ESP32-WROOM-32D through a PCM5102A I2S digital-to-analog converter into a PAM8403D class-D stereo amplifier, feeding rear-mounted miniature speakers or external speakers through screw terminals. Power comes from a rear 18650 lithium-ion cell or a 5V input, with an AP2007 boost converter stepping up to 5V and an NCP1117 regulator dropping down to 3.3V. Solder jumpers keep the programming and operating power paths separate, a detail that stands out to me.



The control layout is where it gets fun. Six tactile pushbuttons sit in a gamepad arrangement, alongside dual potentiometers, two WS2812B RGB LEDs, and a KXTJ3-1057 accelerometer. The 1.44-inch 128x128 ST7735 color TFT is socketed, and socketed connectors accept external rotary encoders. In testing, the unit streamed French internet radio stations, driven by the onboard buttons, the volume knobs, and a smartphone web interface. An I2S drum machine ran on the hardware, plus a tilt-reactive accelerometer visualizer and mini-games including snake, a falling-object catcher, a car racer, and a 3D raycasting maze.



One open point: whether the setup copes with 320k streams was raised but never answered, so that remains an open question for anyone planning a similar build.



Project by KOKENSHA TECH. Watch it on their YouTube channel:

formatting link


The solder jumpers splitting the programming and operating power paths are the detail I would single out. Flashing an ESP32 usually means fiddling with connections while the rest of the board fights you, and having that separation designed into the board from the start looks like it removes a whole category of headaches. On a version 7 board you would expect nothing less, but it is still the kind of thing many hobby layouts skip entirely.

This looks like a really tidy workflow from board design through to working firmware. I am curious about the software side: how were the pin assignments for the screen, buttons and audio worked out for the yoRadio firmware? Was that a manual job editing configuration files, or does the project use some kind of tool to generate the mapping to match the PCB?

The pin mapping was done using the yoRadio web-based configuration generator. So it was not a case of hand-editing files; the maker used that generator to work out the pin assignments, which presumably keeps everything consistent with the board as designed in KiCad. That pairing of a custom layout with the generator seems to be how the firmware side was matched to the hardware on this build.

Since the maker already demonstrated an alternate configuration with dual rotary encoders and a 4-inch SPI display, I would suggest trying that arrangement as a permanent second variant of the board. A bigger screen plus encoders would make a nice desk version, while the current gamepad layout stays as the pocket unit. Sharing one core design across both form factors would suit how this project has evolved across its versions.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required