Twin-engine seaplane that turns into a submarine

Nov 20, 2026 Last reply: 2 hours ago 4 Replies
Jump to replies (4)

When everything works, this craft takes off from the water as a twin-engine seaplane, then floods its ballast, sinks below the surface, and drives forward while fully submerged. That combination of flying and diving in one airframe is what makes the project stand out to me, and on the lake deployment it actually pulled off the dive and the underwater run.



The structure is a mixed-material build. The fuselage and engine nacelles are 3D-printed PLA sections joined with cyanoacrylate adhesive, while the wing and tail surfaces are corrugated plastic cut on an enclosed CNC laser cutter. Carbon fiber spar tubes run through the airframe for stiffness. I think pairing printed sections with corrugated plastic surfaces is a sensible split, since the flat lifting surfaces are quick to cut and replace.



Two brushless electric motors sit on the wings for propulsion. The ballast flooding system relies on hollow pontoons connected by silicone tubing, driven by a 12V DC reversible gear pump. The receiver electronics and batteries sit sealed inside a clear gasket case, and a rigid antenna extension is mounted vertically to stay above the waterline, with radio control signals running at 2.4 GHz.



It was not a smooth road. An early flight test snapped a printed motor mount, which the maker reinforced with carbon fiber rods. Ballast trim was dialed in with an indoor vinyl pool session using foam balancing blocks. The second flight attempt got airborne before crashing onto the water, so the flight phase still looks like the open question here.



Project by PeterSripol. Watch it on their YouTube channel:

formatting link


How does the radio link hold up once the hull goes under? With signals at 2.4 GHz I would expect heavy attenuation in water, so does the rigid vertical antenna really carry the link by itself, or is there more to the setup?

The vertical rigid antenna mount seems like a clever call to me. Keeping the antenna above the waterline means the 2.4 GHz link has a clear path even when the rest of the airframe is submerged. The trade-off is that a tall fixed mast adds drag and could snag on things during recovery, but for a diving seaplane that seems worth accepting.

I would look at replacing the pump-driven flooding with air bladders inside the hollow pontoons. Fill them to rise, vent them to sink, and you get positive control of buoyancy in both directions instead of relying on flooding alone. It could make the trim between surfaced and submerged states easier to hold without adding much weight.

The maker has addressed part of that in the build itself: a rigid antenna extension is mounted vertically specifically to stay above the waterline, and the radio control signals operate at 2.4 GHz. What has not been said is how strong the link is at depth or whether any other signal measures are in place, so the underwater range question is still open.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required