The detail that surprised me most is that a complete set of identical balsa wing ribs comes out of just two plywood templates and a stack of rough blanks. No laser cutter, no CNC machine, nothing fancy. It is plain hand work from start to finish, and the finished ribs still end up uniform in profile and spar cutouts.
The way it is put together is straightforward but well thought out. A printed paper airfoil design is transferred onto plywood using solvent on a rag, and two matching templates are then cut out with a coping saw. A pin vice drills the alignment holes, and metal guide rods hold the templates together while their edges are sanded flush. Rib outlines are traced onto balsa sheet with a fine marker, and the blanks are cut just outside the lines with a sharp hobby knife before each one is drilled through the pin positions.
What stands out to me is the pencil lead shading on the template edges. That gives a clear indicator line showing when to stop sanding, so the whole rib sandwich, stacked on the steel rods and clamped in a bench vise, simply gets worked down until the line appears. Spar notches are then cut across every rib at once with a hacksaw blade and a small flat file, using the template notches as guides, and only afterwards are the guide rods removed.
The trade-off is speed. Cutting blanks oversize and sanding a full stack takes patience compared with machine cutting, but for scratch-built models, RC airplanes or free-flight designs that seems a fair exchange for a method anyone with basic hand tools can follow.
Project by AviPlanes. Watch it on their YouTube channel: