So I finally finished my first resin print and paint job, a little retro-style game character figurine with all those chunky flat facets. Printed great, cured fine, and I was feeling pretty good about it. Then I picked it up this morning and there are already tiny chips along one of the ears where the acrylic just flaked right off the edge of a facet. I sanded everything lightly before priming and did thin coats, or at least I thought they were thin. Maybe I'm handling it too soon and the cure just isn't done? The paint felt dry to the touch when I called it finished, but dry to the touch and actually hardened are aparently two diferent things. Also curious about sealing. Do you guys brush on a varnish or spray one? With all the little corners on this thing I feel like a brush would pool in every recess and a rattle can would flood the whole thing. For what it's worth the rest of the paint seems bonded okay, it's relly just the sharp edges and raised bits that chip. Is that normal or did I miss a prep step somewhere?
How do I stop paint from chipping off tiny resin details?
Nov 20, 2026
Last reply: 21 hours ago
3 Replies
First reply
Sharp edges and raised corners chipping first is normal, so don't panic. Paint physically can't hold on to a sharp point the same way it holds on to a flat surface. On a facet edge the primer and paint layers sit on a knife-edge of resin with almost no surface area underneath…
Read the full replySharp edges and raised corners chipping first is normal, so don't panic. Paint physically can't hold on to a sharp point the same way it holds on to a flat surface. On a facet edge the primer and paint layers sit on a knife-edge of resin with almost no surface area underneath them, and any knock transfers straight through. Flat and gently curved areas flex and spread the load, corners just flake. It's the same reason mini painters 'corner-check' thier figures after a few days of handling.
Yeah the dry-to-touch thing got me too on my first couple minis. Give it a good few days before you really handle them, paint keeps hardening way longer than you'd think. I usually let stuff sit a week before it goes near a display shelf.
For sealing I spray, light mist passes from a bit farther back than you'd expect. Two or three thin passes beats one wet coat every time, and you don't get that pooling in the recesses you're worried about.
Yeah that corner explanation matches what I've seen on my own facet-heavy prints. What helped me was taking a fine sanding stick and just barely kissing the sharpest edges before priming, not enough to lose the facet look but enough that the paint has a tiny flat landing zone instead of a razor point. My last low-poly style figure stopped chipping on the ears after I started doing that. Still got to be gentle with the ears though, they stay the weak spot on every one of these.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required