1. Home
  2. Scale modeling discussions
  3. TBF in 1:18

TBF in 1:18

love the size description of the fuselage. gonna be hanging in my
house for sure...
Craig
formatting link

Reply to
crw59
Loading thread data ...
I'm gonna git me one them bad boys, and then one of the P-51s, and then one of the BF109s and then...
Doug Wagner
Reply to
Doug Wagner

Further Reading

  • 118 vs 135

  • George,No. No compronise - 118 deg. bits are, by far the most common. Darex...

  • R134a Thread size?

  • Well we noticed this really old thread and see that it still gets lots of hits...

  • "DESCRIPTION" In Intralink

  • When there is a workspace or common space open there is a column...

  • 118 Degree

  • In the drill bit thread one person (atleast) mentioned 118 degree drill bits. ...

  • Stuka with Snake fuselage decal

  • FYII'd always wondered if the old Revell 1/32 kit with the red and white...

  • What's It Gonna Be

  • ...

  • What's It Gonna Be ?

  • What it's gonna be is squarer to the axis after you face off the saw cut?...

  • What size plasma cutter?

  • I am getting a new plasma cutter. I have decided on HyperTherm ONLY. I have a...

  • Description in Hole Wizard

  • Is there a way to change the description of user defined and saved holesizes in...

  • I'm In Love

  • With metalAt present I'm holding an "Olde Colony" steak knife stamped JAPAN...

  • Can a FireBird II Fuselage be repaired?

  • I tell me kids, "Gravity always wins"It did tonight.Nose dive into grass was so...

  • a labor of love

  • This link popped up in another NG. Thought it would be appreciated here. Ignore...

  • Model Description property in Drawing

  • Hi,How can I show a model property called Description on my drawing?I used to...

  • TBF/TBM

  • TBF built by GrummanTBM built by Eastern Aircraft division of GMSame design.

  • TBF/TBM Photos

  • Does anyone have an internet source for color photos of TBF/TBM Avenger...

  • 1/6

  • « previous thread

  • New models solutions.

  • Hello, Please check this project and let me know if you have a better solution:...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.