Angled planes and mating

I need to have some planes set up like the following

| / / | / / | / / | / / + plane 2 @ angle 85 + .250" distance | +---plane 1 @ angle 185 + ----right plane

This is for an aircraft I am modeling.

Plane 1 and plane 2 will be a lofted bulkhead.

This is so I can insert the bulkhead and mate on the right plane of a plane at the proper fuselage station.

All the vertical bulkheads are mated on the top planes, front planes and a plane at the correct fuselage station. They mate fine.

I am having trouble mating the bulkheads that are inclined from 180 deg or perpendicular to the top plane, since the right planes are not parallel and are inclined from one another.

Thanks for any help

Reply to
GangGreene
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.