Have a couple of files that when ever I open up a particular part SW will also automatically open up the assembly and the part that was used to create the part I inatially opened (a mirror).
Why is SW doing this and how can it be prevented?
TIA
Steve R
Under tools>options>system options tab>external references>load referenced documents, set to "None".
Or alternately, you could set it to "Changed Only". This will only open the externally referenced documents that have changed since the last time you opened the original document.
I have mine set to "None" though...
Tools > Options > External References > Load Referenced Documents - set to None
Go To TOOLS > OPTIONS > EXTERNAL REFERENCES and toggle the "load referenced documents" to NONE
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.