BUG: Area calculations

I just noticed that area calculations are based on displayed face area and not actual face area.
Create a disk with a hole in the center.
Turn on section view and make sure it cuts the disk in half. Measure the surface area. Now turn off the section view and measure the same face. Should measure twice what it was in the section view.
This is not right. Section view should only open inner details, not change the area of the internal faces.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
Call your VAR and report it. I had the same thing here.
Corey

Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
This is a gotcha so I figured I'd post it to keep the other clones out of trouble. :)
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Polytechforum.com is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.