Gauge Table & Design Table

Does anybody use the 'Gauge Table' or a 'Custom Gauge Table' when they are
building sheet metal parts? Does anybody use a 'Gauge Table' in conjunction
with a 'Design Table'?
When the two are used together, do people leave the material thickness and
bend radii off of the 'Design Table' and just let the 'Gauge Table' drive
those two parameters?
Just curious, as I am setting up a bunch of parts in one file using a
'Design Table' and a 'Gauge Table".
Richard
Reply to
Richard Charney
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.