Hole Tables

Mar 04, 2005 5 Replies

Rate this thread:

Rich 21 years ago

Hi.

Is there a way of getting SW05 to work out hole tables properly? I use a lot of slots and it insists on adding each slot into the hole table as if it's a different size (even though it isn't) this makes the hole table incredibly large and of no use whatsoever. works fine for circles.

thanks

Rich

Vote

Rich 21 years ago

No Takers for this? how does everyone else hanle hole tables?

Rich

Vote

P. 21 years ago

Try this URL:

formatting link

I have used this hole chart utility before SW2005 came out and it wasn't too bad. Haven't tried it on SW2005.

Vote

Rich 21 years ago

Thanks, some good tools there. Unfortunately it doesn't work with slots, only circular holes. I really thought I must be missing something, this should be easy.

Rich

Vote

P. 21 years ago

The TriMech Utility comes with source code. All you have to do is add the slot recognition the way you want it. :)

Rich wrote:

Vote

Rich 21 years ago

Thanks, I'll give it a try.

Rich

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required