The size of the numbers in a dimension seems to be scaled to the part size, so when you zoom in on an area of interest, the dimensions get huge, like covering the half the screen.
Is there a way to make the dimensions a constant size with respect to the screen size, and not the part size?
Thanks in advance Bill Chernoff
Here's one I know!
It's under Tools> Options> Document Properties> Detailing> Annotation Display, Check the box next to 'Always display text at the same size'.
Since it's a Document Property you'll likely need to make this change in your Templates, then never think about it again...
Hope this helps Whit
Thanks very much for the quick (and correct) reply!
Fun, isn't it!
WT
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.