I'm encountering a problem when inserting a base part into a new part.
> Similar to inserting the first part into an assembly, you drag the part to
> the origin. The symbol appears to indicate that the part will lock onto
> the origin and you release the part.
>
> The problem is that the appropriate plane of the base part isn't the same
> as the corresponding plane of the new part, hence the part isn't
> centralised and it is often close enough to not be noticed until it's too > late.
>
> I'm still using SW2006 SP3.0
>
> Has anybody encountered this and was it resolved with a later service > pack.
I don't know if any later service pack fixed it because I gave up on dragging it to the origin. It is much safer to just click on the OK arrow.
Jerry Steiger Tripod Data Systems "take the garbage out, dear"