snipped-for-privacy@chi.com wrote in news: snipped-for-privacy@4ax.com:
I'm modeling a small plastic part and I need help with 2 questions. >
> 1) I'm adding a hole where the end is chamfered 45 degrees. The angled
> end is across the whole diameter. I added an angled plane at the end
> of the blind hole and try to add material but it didn't work.
I don't really understand that description. Sorry
> 2) I'm adding a second hole ("A") 3/16" dia. that intersect a
> perpendicular hole ("B") 1/2" dia. These 2 holes are not in line with
> each other, the centers are offset .250. The depth of hole "A" needs
> to stop when it intersects hole "B". How to I control the depth of > hole "A"?
How about creating a plane through the axis of the .250" hole a perp. to whatever plane you use for the 3/16" hole and then use "Up to Surface" and pick that plane?
Or if you don't want the 3/16" hole ending right in the middle of the .250 hole you could add a second offset plane and use that.