in sw2006 when performing a loft feature without guide curves, solidworks aligns wrongly the connectors, so there is no preview, and a error of self-intersecting geometry occurs. so I click on the single connector which solidworks shows and select "show all connectors", in response solidworks shows me many connectors which I start then sorting and aligning. the problem is that some of those connectors hide behind them many unrevealed connectors, which if I move them there is a bunch of new connectors which comes all from the same spot with an endless stream! sometimes when I select one of them which overlaps in one point many others, then solidworks selects also all the others! sometimes some of the connectors are stuck and wont move at all!
very frustrating.... does anybody else has this problem? I'm almost sure this is a bug.
Gil