Anybody Here Use Atlas RightTrack 5.0 Software?

Nov 25, 2003 1 Replies

Rate this thread:

First reply

NEVYEN

Mac Breck 22 years ago

I'm just getting started and wanted to draw my board size (Max dimensions 97" deep and 76" wide) and wanted the board to appear as a tan color in the design, just to start with so I can see the edges I have to stay within. I'm putting it in my old darkroom which was a wet side/dry side parallel design, so I could have anywhere in the entire center section for pop-up access. I want to put dashed lines on the board to indicate where there is open space below.

Anybody here know how to do this with Atlas RightTrack 5.0 ?

76"

---------------------------------------- | | | | | | | | | | | | | | | | | | | | | | | | | | | | 97" | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |

---------------------------------------- 24" | 24" | 28" | | [sink] | -->door to laundry | | |

------------- -------------- door

Vote

NEVYEN 22 years ago

You can use the line feature to draw dashed lines. There's an icon on the toolbar(top row, right end) that shows a line. Click on this icon, then on the drawing surface the cursor will change to a crosshair and a line. put the crosshair where you want to start the line, then click the LEFT mouse button. This starts the line. Move the mouse vertically or horizontally, and a line will appear from where you started to the crosshair. When you have a suitable length to the line, click the RIGHT mouse button. This ends the line. Then just move the mouse a bit, start another line,and repeat as necessary. These instructions should be in the help file that comes with the software, in case my expanation isconfusing :>)

Vote