1. Home
  2. ⚡ Welding Forums
  3. engine block

engine block

i have a pencil lead size hole on the side of my block on my engine which is
leaking antifreeze its a 6lt diesel will jb weld work to fix this or is there
somthing better ? help please cause i dont have 10,000 dallors for a new engine ?
Reply to
Bo
Loading thread data ...
Yes, back in the day that the radiator freezing and cracking the block was more common there were many fixes. Welding, by the way, is probably not one of the best methods.
Reply to
John B.

Further Reading

  • Welding an engine block

  • Hi everyone,Have any of you had any success welding on an engine block? The...

  • Welding/brazing diesel engine block

  • I have an old log skidder which has a long (around 24 inch) crack linerunning...

  • Best epoxy for engine block repairs

  • OK, you folks have convinced me that epoxy will work for cast iron engineblock...

  • Gage Block calculator

  • There is a gent that has a bunch of metalworking programs on the web, one...

  • I want to Build a Tap Guide Block

  • I need help is there a standard size hole in tap guide blocks?I found a couple...

  • Macro to Insert a Block

  • I am trying to insert a previously created block into a drawing usinga macro. ...

  • Re: NCE BD20 block occupancy detector

  • news:...Scott,There is no delay when the block is clear. The BD20 is simply a...

  • On Topic.... Motor block question

  • Hi All,Is the motor block really necessary in an Estes motor mount? Or can...

  • Update on Suzuki engine

  • While you're looking for a VIN number, also look for pairs of cut-off...

  • Wiring Lionel 153 Signal Block

  • I have created a block using insulating pins (put in the middle rail).I believe...

  • Cracked Block

  • I am rebuilding my Ford 9N tractor engine after a series of unfortunateevents. ...

  • New Pad on the block

  • Here is a link to a pic of a new launch pad we hope to have availible soon,...

  • Detroit 353 diesel -- aluminum block? How to tell?

  • ...

  • Small block chevy cast block weld

  • Need to weld a broken starter mount tab (outside hole) on a SBC block. Hole is...

  • It worked !

  • I was asked to repair or remake an ejector for an old shotgun . After a long...
  • « previous thread

  • Shopping for a Powerful Portable MIG

  • I do ornamental iron to occasional heavy fabrication. I've managed to get b y...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.