1. Home
  2. ⚡ Welding Forums
  3. Inconel 82 - Cast iron

Inconel 82 - Cast iron

Is Inconel 82 good for tig welding cast iron? I thought maybe the high
nickel content might make it good for that? Thanks
Randy
Reply to
Randy Reid
Loading thread data ...
I have used several alloys of inconel and hastelloy to weld cast iron. They work almost as well as pure nickel.
Reply to
Ernie Leimkuhler

Further Reading

  • welding cast iron radiator

  • If the radiator is a cast iron radiator then you will have a much betterchance...

  • Welding rod for cast iron?

  • The gent offering a rod assortment on ebay got me thinking...Ive onlymade...

  • Cast Iron Andiron Repair

  • I bought an old andiron. Goes in front of a fireplace as somewhat of a screen. ...

  • Brazing cast iron

  • I figger one can't be too careful with cast iron. From the OP's...

  • Sawzall for cast iron?

  • Does anybody have experience using a reciprocating saw on cast iron? I haveto...

  • Cast iron welding questions

  • A second thought, are you sure this pulley is actually cast iron and not cast...

  • Welding castiron

  • Hi,-I have stick welded cast iron (DC reverse I think it was) using...

  • Welding two Cast Iron Exhaust Manifolds Together

  • I have a 1950 Ford Truck and want to cut an exhaust manifold in half and weld it...

  • TIG welding cast iron??

  • I have a production cast iron turbo manifold from a company called Apexi,which I...

  • Plasma cutter for cast iron?

  • Habitat has a HUGE steam heat boiler that needs to be cut into smaller pieces. ...

  • filling gap in cast iron

  • I have replaced a stud in a cast iron exhaust manifold, but as luckwould have...

  • cast iron exhaust pot

  • Bit of a long shot, but I wondered if anyone has a cast iron exhaust pot...

  • Black coating on cast iron cookware

  • Hi folks,I bought a small cast iron pestle and mortar today. It has a black...

  • Welding Decorative Cast Iron Post Cap

  • I have no problem welding them on, and did it to several today.When I had a...

  • Free Mig Spool 18"

  • If anyone has a use for a 18" reusable spool, 18" dia. picture link below, it is...
  • « previous thread

  • TIG inverter settings?

  • Have a Eutectic 2002 tig inverter, and wonder if anyone could tell me the basics...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.