1. Home
  2. AutoCAD discussions
  3. Diameter circle

Diameter circle

Hi everyone,
Learning AutoCAD 2013. Please a little help.
The aim is to get the diameter circle, but the line must go through the
circle as the bisecting into 2 parts, not as an arrow that touches the
edge of the circle.
Tnx
Reply to
Electron
Loading thread data ...
In ACAD 10, setting sysvar "dimtofl" to "ON" or "1" produces thru the middle, bisecting dimenstions while "OFF" or "0" produces outside dimensions. R. Wink
Reply to
rwwink
Thanks
Electron
Reply to
Electron

Further Reading

  • descibing a circle diameter help needed

  • Hi allI need some help if i might askI need to Model a chainwheel and drive its...

  • Learning AutoCAD

  • Hi,What's it take as far as training/schooling to learn one's way around...

  • Re: hi everyone

  • hi neosiswhat's up?--Hasta LuegoIrshaad(Faster than Bruce Lee)remove INVALID...

  • Hi Everyone!

  • Hey right back at ya Clint!!Tell us a little about yourself, or just jump right...

  • A little help, please

  • I FINALLY got a forge yesterday. My mother-in-law was using it for a bird...

  • hi help me please friends

  • Hi folks,I need a help. As I am basically an electrical engineer I havesucceeded...

  • Boxford help please

  • Hi,I have to move a boxford lathe soon. I only have a photo of it so far. I...

  • A little help please.

  • I am asking for some help from you people in an area I am about toenter.I have...

  • Hydraulics help please

  • The 8 foot Frink on my old Ramcharger ised 2 cyls of less than 2 inches...

  • autocad 2013 & rasterex-pro: snap function

  • I have just installed autocad 2013 & rasterex-pro: I do not think it's the...

  • AutoCAD little secrets

  • All you may not know about AutoCAD is on...

  • Flange with bolt circle LISP

  • Hi ya,I just feel like sharing a little thing I did a while ago. I love it,...

  • The free circle tools for AutoCAD.

  • Circle Tools is a set of tools which extend the AutoCAD's circledrawing...

  • ghost blocks

  • Hello, can someone help or tell me if its possible to find and replace ghost...
  • « previous thread

  • SYSTEM NAVIGATOR

  • Can I use System Navigator 2013 by Exeone to view DWG files ???
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.