1. Home
  2. AutoCAD discussions
  3. Spline to Poly line?

Spline to Poly line?

Loading thread data ...
Separate the offending item(s); saveas R12 or R13 then reload or block into your drawing. (Or skip the first part if you don't mind losing some of the newer (14,2000,2000i,2002,2004) information.
Reply to
Roarmeister
Manually keep track of scale -> WMFOUT -> WMFIN -> Explode -> restore scale.
Conny
"Roarmeister" skrev i meddelandet news: snipped-for-privacy@4ax.com...
Reply to
Conny Klasson
Grab SPL2PL.VLX from
formatting link
It will convert them in place with no DXF/WMF hoops to go through.
Terry
Reply to
Terry W. Dotson

Further Reading

  • Convert a line to a spline?

  • Can anyone tell me how to convert a line, arc or circle to a spline? Thanks

  • Where to get Bristol Spline screws?

  • Does any one knows where I can get small Bristol Spline screws? (2-56,...

  • Poly pipe entering crawlspace

  • The hole should be below the frost line. You can't bend poly pipe in that...

  • Poly-Choke Sharpeng Fixture ?

  • Any one know where to get a users manual for a poly-chokedrill and tap...

  • Trim to a Spline

  • i got a spline with lines passing through it, i need to trim these lines using...

  • Possible to turn HSS with HSS tools ?

  • Hi, I read that it is possible to turn HSS with HSS tools but it seems hard to ...

  • Possible to bend conduit into circle?

  • I sometimes use conduit to make yard ornaments to put lights aroundfor...

  • Spline to Arcs

  • HiHo;PEDIT SPLINEHope I understood your question.

  • Centerpoint Arc to Spline?

  • Hi,I am drawing a centerpoint arc from three points, namely thecenterpoint,...

  • Possible to shrink expanded O-rings

  • Hi,I have four tiny but very expensive O-rings used for dust scrapingaround...

  • Machine spline for servo horns

  • I have a lathe and milling machine and would like tomake my own parts for servo...

  • Flatten Spline

  • I need to be able to flatten an extrusion defined by a spline. Thiswill be used...

  • acad 2004 - is it possible to extrude region via 3D spline

  • to get some organomorphic forms like curved tubes, curved road and so on?This...

  • spline shaft

  • Hi,I'm trying to make a 10" shaft w/ a 1.5" spline in the center. anyoneknow...

  • Spline type

  • Does anyone know what type of spline SW creates when you import xyzpoints from a...

  • HP OMNIBOOK 4150

  • I have installed 2002 on my 4150 and have a curious problem with the display....
  • « previous thread

  • DWF: Autodesk a day late and dollar short

  • I just visited the AutoDesk website to find that they are now pushing users...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.