Mastercam

Who is using Mastercam X5 MU1?
Am have an issue or 2, need to see if it is the software or the
operator.
Reply to
"D"
Loading thread data ...
"\"D\"" wrote in news:ee527fc8-03b2-482a-8df9- snipped-for-privacy@r33g2000prh.googlegroups.com:
What kind of problems?
Reply to
Neurosis
Found the primary point of responsibility to exist in the chair, more information was needed to properly align large object in chair with program format, and a few mouse commands too!! Alas, they did change the backplot feature, will know more later, but for now, the part used to rotate on a 4th axis backplot, now it doesn't, they are looking into it.
"D"
Reply to
"D"

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.