Mastercam X3 Feature Based Machining

You don't see Mastercam X3 Feature Based Machining discussed on the e-
Mastercam forum yet.
Why would this be?
You can read my opinion of Mastercam X3 FBM on the main Jon Banquer
blog.
Follow the link below.
Jon Banquer
San Diego, CA
formatting link

Reply to
jon_banquer
Loading thread data ...
For someone who complains so much about emastercam, sure spend a lot of time lurking in the shadows over there like Gollum.
Reply to
Joe788

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.