Stepper motor control via serial

- C
- Carl Gilbert
  
  Contact options for registered users
posted
20 years ago

Sun, Feb 15, 2004 6:48 PM

Hi I have a stepper motor and PCB from

formatting link

and have connect the device to my PC through the serial. When using the downloadable application for the device, I receive a comms error.

Does anyone know how to send data to the device to get the motor to turn?

Regards, Carl Gilbert

Device manual:

formatting link

Loading thread data ...

- M
- mindspringnews
  
  Contact options for registered users
Vote on answer
posted
20 years ago

Sun, Feb 15, 2004 8:10 PM

You need to setup the serial port to be operating the same as the device. Should be in your SW somewhere.

XML Sitemap
Terms of Service
Privacy Policy
Contact

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.