GM 10-CUT CODE SERIES AA00-7T51 BLANK= B86,B89,B85 DEPTHS:
1.=.315(NC) 2.=.290 3.=.265 4.=.240ACTUAL CUT DEPTHS
1.=(NC) 2.=2 CUTS- .0125 EACH CUT 3.=2 CUTS- .025 EACH CUT 4.=2 CUTS- .0375 EACH CUTCORRECTOMOONDO?????
GM 10-CUT CODE SERIES AA00-7T51 BLANK= B86,B89,B85 DEPTHS:
1.=.315(NC) 2.=.290 3.=.265 4.=.240ACTUAL CUT DEPTHS
1.=(NC) 2.=2 CUTS- .0125 EACH CUT 3.=2 CUTS- .025 EACH CUT 4.=2 CUTS- .0375 EACH CUTCORRECTOMOONDO?????
hey, go to
--Shiva--
mine only went to 7n45 lol
YES, FROM ONE SIDE..NOT overall.. the drop is .025
2 at .025 EACH... the depth DIFF is .025 *2 makes .050 OVERALL2 at .,050 EACH makes less .1
2 at .075 each, makes less .150
nope..
a #4 cut CUTS INTO the thick part of the key, BARELY, is how I eyeball them.. if its just ABOVE that thick part, its a 3.
spacing FROM THE TIP
204 296 388 480 572 664 756 848 940 1.032the C C is .092
--Shiva--
goma865 has snipped the incorrectiveness-Thanks again Shiva!!!!
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.