1. Home
  2. ⚙ Mechanical Engineering
  3. decision based design

decision based design

Hi,
does anyone around here have expreince with decision based design? If
so, would you think its principles can be applicable to other
engineering disciplines, eg. chem. eng.?
Thanks,
Mat
Reply to
mantreal
Loading thread data ...
I am not faimiliar with this buzz-word. Please explain to me what non-decision based design would look like.
Reply to
wave_man

Site Timeline

Related

  • Lathe decision

  • After many weeks of scouring the universe, I have found 3 lathes thaare...

  • IMAA BOD Decision

  • IMAA Board of Directors - thumbs down on IMAA e-mail list.Hi Red,As anticipated,...

  • BATFE Court Decision

  • I've been buying H I and J motors for years without needing my LEUP....

  • Does anyone here have Comcast?

  • I sometimes fall fast asleep when I am machining but I have never been filmed...

  • Big Decision Time

  • Hi,I am about to start my first layout in 'n' and am torn between going...

  • Re: Month of decision

  • It's always an un-election. You're not voting for President. You're...

  • Spirit 100 wing decision

  • Hi, I have recently returned to R/C gliding after a long (20 year) absence.I...

  • Does anyone have or use this ... Henrob 2000-welder

  • I was looking at this today. I am just getting starting in blacksmithing and...

  • Re: Review - DML 1/35 scale German Wiking Division - Kovel 1944

  • Hi Cookie, just to add my two penn'orth to the "Great Verboten Device...

  • Job outlook...i have a decision to make

  • We have often heard that people who are good survive at all times.Unfortunately...

  • Does anyone have the new Atlas N-scale Shay?

  • Have any of you tried out the new 2-truck Shay yet?It's only a matter of...

  • Newbie rc opinion request

  • wrotePilots of full sized planes usually have a very hard time flying RC...

  • Unimat Micro Lathe - Source wanted

  • It looks like Taig is the micro Lathe of choice. I guess I'm going to...

  • Anyone have a Rapidor?

  • I have just invested in an old Rapidor power hacksaw (one that takes14" blades),...

  • Fuzzy Inference System (FIS) Based Decision-Making Algorithms for CMM Measurement in Quality Control

  • FULL ARTICLE HERE http://amizo1.googlepages.com/FUZZY.htmAbstractThe...

  • ZENA welders <- anyone have experience with this equipment ?

  • I spent much of my time either trying to fix what so called"engineers" tried...

  • Does anyone have a car battery charger that you ACTUALLY LIKE

  • All that is necessary is to have current limiting electronics...OK... I have...

  • Does anyone here use (or have) the Draco 12 Ditizer by Qtronix?

  • Does anyone here use (or have) the Draco 12 Ditizer by Qtronix?

  • final decision: i'll go for railroad modeling :)

  • as, i think, many newbie modelers i'm trying to decide the scale....

  • Anyone here rebuild a F163 engine

  • My SA200 is leaking oil from front and rear seals. Will probably put an...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.