Dremel EZ Lock 1-1/2 Cut-off Wheels?

John Doe wrote in news:VLfyj.4606$tW.3489 @nlpi070.nbdc.sbc.com:

The biggest problem I've had with them is actually getting them on/off the spring-loaded mandrel. I've found that it's best to have the mandrel chucked into the tool first.

I've used them at rotational speeds up to 56K RPM without difficulty.

Have you noticed any vibration maybe caused by the cutoff wheel being spring-loaded? Mainly curious. Thanks.

By the way. Too bad the entire outside of each cutoff wheel has a permanent label attached to it. I find the outside of other cutoff wheels very useful for smoothing edges/corners. This one requires sanding first. Changing a cutoff wheel is difficult. Besides while it's in the tool, (if convenient) holding the mandrel shaft against something like the corner of a table makes changing the cutoff wheel easier.

No vibration at all - even with the HF pneumatic tool.

Say WHAT???

Besides while

Why not simply use a thin cutoff on a standard mandrel? Changing mandrels is a 10-second activity and can be done without tools.

Otherwise, use the "inside" to do your work!

You misspelled "trolling is a 10 second activity and can be done without brains".

Go f*ck yourself.

newssvr25.news.prodigy.net!newsdbm05.news.prodigy.net!newsdst01.news.prodigy.net!prodigy.com!newscon04.news.prodigy.net!prodigy.net!newshub.sdsu.edu!out03a.usenetserver.com!news.usenetserver.com!in01.usenetserver.com!news.usenetserver.com!in03.usenetserver.com!news.usenetserver.com!pc02.usenetserver.com!fe18.usenetserver.com.POSTED!abb8b220!not-for-mail

John Doe wrote in news:NAmDj.23736$ snipped-for-privacy@newssvr25.news.prodigy.net:

ROFLMAO!

Since you have admitted to TROLLing, I'll add you to the filter.

FWIW, I'd almost be willing to wager that I've worn out more Dremels than you have welcomes.