For Sale: Unimat 3 and accessories. Included are the following: Lathe bed, headstock and tailstock, power feed, drill press/milling head, fine feed for drill/mill head, dividing head with #24 index plate, face plate, milling table with clamp set, steady rest, machine vice, 3 jaw chuck, 4 jaw chuck, Jacobs drill chuck, standard toolpost, adjustable toolpost, 2 dead centers, 1 live center, lathe dog, lefthand quick change tool, righthand quick change tool, cutoff tool, 90*/45* boring bar w/ v blocks, center drill, 2 flute end mill, counter sink, extra drive belts, various wrenches and pins, box of 10 unground tool bits, 1 ground tool bit, adapter to use any chuck on mill table or cross slide, original instruction book and box, but the box is not in good shape. The lathe has been stored in the box since new, and used a few times. It is in excellent condition, but is used and you'll find a small amount of chips and swarf in inaccessible spots. It was cleaned and oiled after each use. $650 plus shipping and insurance.
Rev. Terry Mills snipped-for-privacy@ARRL.NET