1. Home
  2. ⏣ General Metalworking
  3. FREE 4a single phase motor

FREE 4a single phase motor

This POS does not sell, though it runs fine. Shipping is $9, local
pickup is free. My actual shipping cost is $8.10, but with paypal fees
$9 will be about even.
formatting link

i
Reply to
Ignoramus32209
Loading thread data ...

Site Timeline

Related

  • Single phase motor

  • Hi again.Well I'm looking at a Denford Viceroy Centre Lathe. TDS1, but it...

  • Bridgeport 3 phase to single phase

  • I'm be surprised if you couldn't find a used 3 phase motor and...

  • Three Phase/Single Phase Voltage Fluctuations

  • Hi everyone.I hope this is the right group for this post of mine - hoping...

  • Single phase motor controller.

  • I know this is a very rudimentary question, but here goes anyway.I've got...

  • Single phase motor problem

  • I have an old single phase 110V 5.6amp 1/3HP 1200rpm induction motorthat...

  • 240v Single Phase GFCI - Wiring Issue

  • Ok - I'll start off by saying I am NOT an electrician - and No, I amNOT...

  • Boxford STS lathe conversion to single phase

  • I have just bought a 3 phase Boxford STS and would like to convert it to...

  • Bad single phase motor? Diagnostic?

  • I have seen a few single phase motors that acted badly, but not likethis. I am...

  • single-phase alpha-beta / dq transformation

  • Hello everyone.I am currently working on a single phase converter and need a to...

  • 3 phase motor guru's?

  • Greg here is a quick scope of what and how a 3 phase motor is connected. This...

  • Enco Free Shipping Codes this month?

  • Any valid Enco Free Shipping Codes this month? :-)Marty

  • 3-phase motor on single phase supply

  • I want to use a 3-phase 400V AC motor an a 230V single phase supply.It says...

  • measure single phase 240v motor

  • a motor has been tripping out the breaker. (single phase 240v)If i disconnect...

  • Free POS refrigeration compressor

  • Some dusty POS military surplus "refrigeration compressor" completewith a pulley...

  • Converting Miller GoldStar 300SS to single phase???

  • My guess is his fried would hook up a capacitor like a motor phace converter. ...

  • single phase reversable motor wires

  • I just let all of the smoke out of the switch box from a single phasereversable...

  • Single phase electric motor problem

  • Although this is not strictly an engineering problem, I hope there isomeone who...

  • Big single phase MIG recommendations

  • I buy and sell welders all the time, and I do not recall seeing singlephase MIGs...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.