1. Home
  2. ⏣ General Metalworking
  3. FS Atlas Half nuts

FS Atlas Half nuts

I have a set of the halfnuts (Longitudinal for the Atlas 10"and12"
lathes. I believe they are the same part. Never used or installed
Sell for half the price Clausng charges. free shipping in USA
snipped-for-privacy@webtv.net
619 265 1883 San Diego
Reply to
daniel peterman
Loading thread data ...

Further Reading

  • Atlas 10 or 12 Half nuts FS

  • I wouldn't normally use the group for this purpose but I am in debt wayout...

  • Atlas lathe questions

  • When using the back gears on my 12" Atlas lathe, I hear a lot of gearnoise, as...

  • FS- Atlas 7B metal shaper $700

  • Atlas metal shaper with original vice, handle and 2 tool holders. Powered by a...

  • disassembly of Atlas N scale locos

  • I have an Atlas N scale road diesel about a year old. It ran great for...

  • Atlas Lathe Timken Bearings

  • I have an Atlas metal lathe w/ 10" swing -- quick change gearing --48" bed, etc....

  • AMMCo vs Atlas Shaper

  • I own an AAMCO/ Delta. I have only seen the Atlas in pictures. It may offend...

  • Longitudinal feed gear

  • I have a 24-150. The longitudinal gear is worn and needs replacing. Anyone know...

  • Atlas shaper advice needed

  • I am now the proud owner of an Atlas 7B shaper.for details...

  • Atlas TR12 demonstrator

  • I recently acquired an ancient Atlas/Rivarossi N scale SW1200 in the GM TR12...

  • Boring out Atlas Lathe headstock?

  • Has anyone ever bored out the headstock of an Atlas 10" or 12" lathe? I know...

  • Carriage play on Atlas Lathe

  • Hi all,I just ordered in a new Phase II quick change toolholder. Man I had...

  • Does anyone have the new Atlas N-scale Shay?

  • Have any of you tried out the new 2-truck Shay yet?It's only a matter of...

  • HELP Atlas 12x36

  • I seem to have a foul-up. I broke (re-broke dpo fix) the gear case onthe apron...

  • Craftsman (Atlas) 12x36 lathe - opinions?

  • I really like my 1938 Craftsman.I did not need a 3rd lathe, but it is getting...

  • 9"hercus lathe ( southbend copy ) half nuts

  • Hello Twistdrill,If you want to take the easy way, the half nuts are probably...

  • Adding a hinge to a harbor freight PORTABLE bandsaw?

  • What I am thinking of doing, in one form or another, is adding a hinge to a...
  • « previous thread

  • MSC Ships me a Toolbox (Tale of Woe)

  • As you may recall I asked a while back for suggestions on a toolbox since my...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.