FS: Bridgeport Mill and Myford ML7 lathe in UK

Mar 22, 2005 2 Replies
Jump to replies (2)

Hi all,



I am disposing of my entire amateur engineering workshop, to include:



Bridgeport Series-1 Mill



------------------------


3-phase motor, with single to 3-phase converter & electronic speed control. Power cross feed, Mill Vice, various collets, clamping kit, slitting saws, Drill chuck, Clarkson end mill holder, various end mills, Dial Gauge, Boring head, Mitutoyo Digimatic Caliper gauge, Heidenhain DRO. Recently overhauled by local specialist, and in *very* good condition.

Myford ML7



----------



Single phase motor, Burnerd 3 jaw chuck, 4 jaw Chuck, large 4 jaw chuck, backplate, various steadys, Live center, 2 x Drill chucks, screwcutting gears, much tooling



Large metal cut-off saw, various other bits.



Photos of the machines can be seen at :



formatting link
I would like to sell the whole workshop, in one go, expecting IRO £1900, & open to negotiation!



Thanks, Peter DOT Moreton AT virgin DOT net


In article , Peter Moreton writes

Peter, you'd probably target your ad a little better by posting it to uk.rec.models.engineering.

You'd also do well to chat with John Stevenson over there. Very nice guy who (together with a few others) is running a free UK M.E. ads service.

Good luck!

Good point, thanks!

PM

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required