[Fwd: Newall C80 installation]

Jan 16, 2007 1 Replies
B

---------------------------- Original Message ---------------------------- Subject: Newall C80 installation From: "Ben Carter" Date: Tue, January 16, 2007 6:07 pm To: post+ snipped-for-privacy@andrew.cmu.edu



--------------------------------------------------------------------------



I'm about to install a new 3 axis Newall C80 on my old Bridgeport J head. The directions seem to be fairly complete but I've read some other opinions here and there on the web that contradict the instrctions in some ways. Has anyone successfully done this set-up and if so were there any surprises?



thanks



Ben


Vote
Twitter Facebook LinkedIn
L

directions seem to be fairly complete but I've read some other opinions here and there on the web that contradict the instrctions in some ways. Has anyone successfully done this set-up and if so were there any surprises?

I fitted a C80 3-axis to my Centec 2B with no real problems. The instructions were general and in no way specific to a Centec mill. If you have instructions specific to a Bridgy then my experience is clearly irrelevant to your situation.

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required