1. Home
  2. ⏣ General Metalworking
  3. Good Source for Off-The-Shelf Step-Drills in Canada (Calgary?)

Good Source for Off-The-Shelf Step-Drills in Canada (Calgary?)

Anyone have a good source for off-the-shelf standardized step drills in
Canada - specifically Calgary, Alberta if possible?
Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills:
formatting link
Spindle Drills:
formatting link

V8013-R
Reply to
Joe AutoDrill
Loading thread data ...

Further Reading

  • Bux magnetic drills any good?

  • I've seen a magnetic drill on eBay which I'm tempted to bid on. The base...

  • 0-80 Tap source in Canada?

  • Anyone have a reliable source for 0-80 UNF tap tooling in Canada?Regards,Joe...

  • 0-80 Tap Source in Canada?

  • Anyone have a reliable source for 0-80 UNF tap tooling in Canada?I should...

  • Step pulleys source

  • Hello all,What's a good source for step pulleys?tiaBigJoe

  • Off the shelf plastic miter gears?

  • Anybody know of a source? Looking for a small quantity in the range of ~1" to...

  • Source for Clinton engine parts in the UK?

  • Hi all,I have a Ransomes cylinder mower which probably dates from the 1960s....

  • HF Step drills? Aye or Nay

  • I see they have their "unibit" style step drills (pack of 3) for less than $10...

  • Aluminum oxide source in the San Francisco bay area

  • Hello all,I have been looking for some aluminum oxide to use as a blasting media...

  • Calgary SolidWorks user group

  • As some of you out there are aware, and some not. There is a new user group in...

  • Storage shelf welding project completed

  • The storage shelf project I used as justification to buy a welder is...

  • Need source for HSS in Canada

  • Mat Travers tools has 1/4 x 1/2 only up to 4" long but they do have 1/2 x 1/2...

  • Any builders in Calgary AB?

  • DrPepper wrote innews: snipped-for-privacy@4ax.com: I have just experienced...

  • Elliot drills any good ?

  • I'm replacing my meddings pillar drill with a small bench drill for mylittle...

  • MAAC of Canada insurance no longer good in the USA.

  • ----- Original Message ----- From: TonyTo: Bill Davison ; 'Bob Dixon' ;...

  • Harrison M300 lathe help needed

  • We've recently acquired for our small workshop, a used M300 which had a problem...
  • « previous thread

  • gold leaf

  • I need to restore tarnished composition leaf on ceiling. The gilding is done on...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.