I just made a new stock rack. Old rack had angled arms for round stock, that was a PITA, stock would always roll together and make it a bitch to get the peice in the middle or back out. New rack has all level arms, with a hole drilled for a stop on the end. I hope this works out much better.
Every time I'd get a stock delivery I was always asking the truck drivers if they had seen a good way to store stock. Every one said stock racks are always a mess, some even worse than mine (which I find hard to believe).
I think I'll just store aluminum on the old rack and put only steel on this one.
Thank You, Randy
Remove 333 from email address to reply.