Jackson vertical mill - information?

I'm going to look at a Jackson vertical mill tomorrow night.
I've not found out much about them.
It appears they were a WW2-era machine, and probably BS#9 spindle taper.
Does anyone here have any knowledge of them beyond that?
Is this a full-size mill, or a Rockwell size?
Rex
Reply to
RBnDFW
Loading thread data ...
Get a BP or clone and stop screwing around. The big cost is tooling.......not the machine. Steve
Reply to
Steve Lusardi
I have a very nice Millrite MVN and a minimill, and plenty of tooling for both.
Some of us like restoring old iron. This one is about the size of a Rockwell.
Reply to
RBnDFW

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.