Have a Jet JTM-830 Vert. mill that is serving me very well. Appears this model is no longer made, serviced or supported .
And I appear to have lost the users manual for same.
Tried the Jet support folks and all they had was an exploded parts view and part numbers. (which, I suppose, won't be of much use if they are no longer supporting this unit)
Any one out there have an owner / user manual for this model and would be willing to copy same?
Thanks
Bob rgentryatozdotnet
Might work -
---------------------------------------------------------------------------------------- BINGO!!
Just like mine. Thanks Larry!!!
Got a copy on order.
:) Bob :) rgentryatozdotnet
------------------------------------------------------------------------- Thanks for the comeback Gunner. . . however. . . That is quite a different mill from my little 830. Would be nice to have one like that but don't know where I'd put it.
The lead from Larry was spot on. Got a copy on order.
Thanks again
Bob rgentryatozdotnet
------------------------------------------------------------------------------------ That unit is 'similar' to mine, enough so that I could use his mods for the power feed as a starting point for adding one to mine.
Thanks for the link!
Bob rgentryatozdotnet
Have something to add? Share your thoughts — no account required.
Ask the community — no account required